The Peek-A-Flame Relay Series 7000 is a sensor module that activates a relay when a flame is detected by an ultraviolet sensor or a flame rod. The Peek-A-Flame is for flame detection only; it will not detect safe start, safety lockout, load switching or any other safety procedures.
UL recognized & FM approved.
Plugs into an Industry Standard 11-pin base.
Test point at the front permits direct reading of the flame signal level, 0-12 VDC.
“Flame On” Light
“Flame Fail” Light indicates Test condition and can be activated remotely. By applying 12-120 VAC or VDC to Pin #10. Contacts are also activated between Pin #5 and Pin #6. A test signal is ouput on Pin #11.
Analog output on Pin #11 for remote monitoring by a PLC or similar device.
Please be aware that this product will be discontinued on October 26, 2018. This product will be replace by Honeywell 7800. Please click the link below for more information.